Shenzhen Kangli Silicone Co., Ltd
KLB Siliconetech Best Solution For You,Advanced Science
Add to Cart
Silicone Release Agent CL-T10B
Product description
CL-T10B, one component water-based release agent for silicone rubber mold production. Excellent and durable releasing effect and would not transfer to the products itself. Over 5 times long-term using, also can be used as cleaning agent in the releasing process.
Mainly apply to silicon rubber producing, especially for high quality requested silicone rubber releasing from the mold.
Application:
All kinds of silicone rubber producing.
Physical Properties:
Appearance: Translucence liquid
density: 1.01 Kg/L
PH: 11.8
Method of Application:
CL - T10B as spraying process on a clean and hot mold. It can be diluted by pure water at ratio:1~2 times or depending on the spraying device.
1. Spraying at least 3 times with thin and uniformly on the hot mold.
2. 5 minutes delay for each spraying time to make the water be volatilized deeply.
3. Please keep 10-25cm between spray gum and mold. It would be better to use spraying
equipment with constant pressure.
4. The best effect should be based on constant temperature over than 95℃.
5. Please according to the production requirements to re-spray CL-T10B.
6 . Don't spray too much to avoid the remained release agent in the mold,
Storage and Treatment:
This agent should be stored at 0-49 ℃ in the warehouse. Cover and tighten the containers soon after using which preventing evaporation or pollution. Please warming up the agent to room temperature before using if the stored temperature is lower, Proper usage won’t cause harm to human body.
Shelf Life: 12 months
Packing: 5litres/barrel and 15 liters/barrels